片语

water turbine generator rotor水轮发电机转子

turbine generating rotor汽机转子

turbine e rotor汽轮机转子

turbine s rotor气轮机转子

steam-turbine generator rotor汽轮发电机转子

power turbine adjustable rotor blades动力涡轮可调转子叶片

turbine lp rotor汽轮机低压转子

steam turbine s rotor汽轮机转子

turbine generator rotor汽轮发电机转子

英汉例句

• through the theoretical analysis, we have sought the cause of its deficiency, and advanced a new method and some formulas to calculate axial elongation for steam turbine rotor in transient conditions.

  经过理论分析和推导，找出了传统方法所存在的问题，同时提出了精确计算转子在瞬态过程中轴向膨胀新的计算方法和公式。

• the design principle, characteristics and application of zzc 1 bore ultrasonic testing system for turbine rotor are described.

  叙述了zzc-1型转子中心孔超声检测装置的原理、性能及应用。

• the actual example of straightening an accidentally distorted reaction type industrial turbine rotor is presented together with a description of the rig and applied technique.

  本文较详细地介绍了反动式工业汽轮机整锻转子因故弯曲后的矫直事例，包括矫直的设备与工艺过程。

• finite element analysis program was used to calculate the stress of 300mw turbine rotor in straightening the axle, and the effect of each factor is analyzed combined with the trial result.

  应用有限元分析程序对300mw汽轮机转子直轴进行了应力计算，并对各影响因素进行了分析，结果表明退火处理过程中残余应力产生的塑性变形量不可忽略。

• the torque tube unbalance of turboshaft power turbine rotor is investigated and a test method for estimating the unbalance is introduced with high speed dynamic balance test.

  对涡轴发动机动力涡轮转子测扭基準轴的不平衡量进行了研究，提出了一种通过高速动平衡试验估算出测扭基準轴不平衡量的试验方法。

• using the results from finite element analysis of turbine rotor suppressed in heat stress, and simplified theoretical calculation equations, a mathematical model is established.

  采用汽轮机转子热应力的有限元分析结果和简化的理论计算公式，建立汽轮机转子热应力的数学分析模型。

• this paper takes a type gas turbine rotor as an example to analyze its natural frequency and modal shape.

  介绍了某型燃气轮机转子模态试验，试验测得转子静态固有频率和模态振型。

• it is pointed out that the turbine rotor bearing system design should be knowledge-based design.

  阐述汽轮发动机组转子轴承系统的摩擦学设计应当是基于知识的设计。

• aero engine turbine rotor design is a repeated process that needs much time. there is much work to do to adjust the structural size.

  航空发动机涡轮转子设计是一个反复协调的过程，其中存在着大量结构尺寸的调整工作。

• it also presents a proposal for blade shape drawing, and a preliminary discussion about the damage or turbine rotor by sand particles in the silted water stream.

  介绍了一种在水电厂检修中简单易行的翼型测绘方法；对于含沙水流对水轮机转轮的破坏进行了初步探讨。

• in the light of the problems involved in a steam turbine rotor fault diagnosis proposed in this paper is a new diagnostic method based on a fuzzy self organizing neural network.

  针对汽轮机转子故障分类问题，采用模糊数学和自组织特征映射神经网络方法诊断汽轮机转子的故障。

• this load spectrum which is the groundwork for the strength and life of the turbine rotor system provides the basis of formulating accelerated mission test spectrum.

  此载荷谱是涡轮转子部件强度和寿命计算的基础，并可为以后编制该发动机的加速任务试车谱提供依据。

• the coupling vibration behaviors of a particular turbine rotor have been analyzed.

  本文分析研究了特型涡轮转子多重耦合振动系统的固有特性。

• the turbine rotor is supported in the bearing housings and is radially independent from the outer casing.

  涡轮转子通过轴承座的支撑径向独立于外机壳。

• based on the advanced computer visualization technique the pre and post-processing of finite element analysis of turbine rotor thermal-stress are conducted.

  结合汽轮机转子热应力有限元分析问题，提出了适用于汽轮机转子有限元热应力分析的前后处理可视化的实现方法。

• generally speaking, most of the wind turbine rotor is a rigid rotor, usually at low speed balance can be achieved and ensure the accuracy of the use of wind turbine rotor.

  而一般来讲，大多数的风机转子都是属于刚性转子，通常在低速平衡就能达到和保证风机转子的使用精度要求。

• the simplest model of a horizontal axis wind turbine (hawt) is one in which the turbine rotor is replaced by an actuator disk which removes energy from the wind.

  水平轴风力涡轮机（hawt）的最简单模型是：其涡轮机转子由从风力中获取能量的促动盘代替。

• in this context, the term 「small」 should be understood to mean a turbine rotor of less than about 10 meters in diameter.

  在上下文中，术语「小型」应该理解为表示涡轮机转子的直径小于大约10米。

• the parametric method is used in the process of turbine rotor design and analysis in this paper.

  笔者引入了近年来普遍提及的参数化思想，用于涡轮转子的结构设计与分析中。