英语释义

1. a stress sufficiently beyond the elastic limit that the material begins to exhibit plastic properties and continues to deform without further increase of load —used especially of tension — compare yield value

片语

yield d point屈服点

low-yield-point steel damper低屈点钢耗能器

ultralow-yield-point steel极低屈服点钢材

ultra-low-yield-point steel极低屈服点钢材

plastic yield-point塑性屈服点

yield-point phenomena屈服点现象

compressive yield point抗压屈服点，压缩屈服点

英汉例句

• because of the lower yield point of rotor material, the local plastic deformations are found during operation at rate speed.

  由于转子材料屈服点较低，在额定转速时，局部会出现塑性形变。

• we introduced a structure equation with macroscopic parameters, which can explain both the yield point phenomenon and strain-ageing of low carbon steels.

  我们提出一种新的来自于宏观量构成的理论，将低碳钢的屈服及时效现象统一于同一个理论之下。

• the chemical components and microstructure are analyzed for the hot-rolled reinforced bar, of which the yield point is not so clear, some measures proposed.

  对存在屈服点不明显问题的热轧带肋钢筋的化学成分和组织进行了分析，提出了改进措施。

• although there is no yield point , one needs to be defined.

  虽然不能具体定义屈服点，但是必须确定下来。

• the yield point represents the dividing line or transition from the elastic to the plastic region of the curve.

  屈服点是弹性变形区域到塑性变形区域之间曲线的过渡点。

• it was observed that the lower yield point was subject to a greater degree of scatter than that of the upper yield point.

  业已观察到下屈服点比上屈服点易产生更大的散布度。

• the conventional photoelastic modes and procedures suffice to indicate whether or not the yield point of the material of the prototype will be exceeded.

  常用的光弹性模型和方法都是以指明原型材料的屈服点是否将被超过。

• therefore, under the 1900- point market with a dividend yield point of view of a reasonable valuation.

  因此，在1900年与一个合理的估值观点股息收益率逐点市场。

• if the design is based on the strain hardened properties, the allowable design stress will usually be above the actual yield point of the haz.

  如该设计基于应变硬化性能，设计应力通常在haz实际屈服点以上。

• the straight-line portion of the diagram up to almost the yield point is known as the elastic region of the diagram.

  从图表中的直线开始上升一直到屈服极限点是弹性变形区域。

• weld shrinkage-induced local strain to yield point strain often several times, than the strain due to the load is much larger;

  焊缝收缩诱发的局部应变时常达到屈服点应变的数倍，比荷载引起的应变大得多；

• the yield point is the stress at which there is an appreciable increase in strain with no increase in stress, with the limitation that, if straining is continued, the stress will again increase.

  屈服点是在应变有可观增加，应力没有增加的应力极限，在这个极限下，如果应变继续增加，应力就也会增加。

• the (results) showed that, (1)the limited strength of bridge with cfcc is larger than that with steel cable, (because) cfcc has no yield point and share more load at ultimate state;

  分析结果表明，（1）由于拉索没有屈服点，在极限状态下可以分担比较多的竖向荷载，桥梁的极限承载能力有所提高；

• the value of stress under air pressure test shall not exceed 80% of the yield point of the material in test temperature;

  气体压力试验时的应力值，不得超过试验温度下材料屈服点的80%。

• in this paper, a method using high precision position information of yield point obtained by differential global positioning system(dgps) to determine the real harvest area was presented.

  采样周期内实际收割面积计算误差造成的产量数据误差是联合收割机计产数据中的一种常见误差。

• an experimental and theoretical study of the earthquake mitigation effect of hysteretic dampers using ultra low yield point steel was presented in this paper.

  本文通过试验研究和理论分析探讨极低屈服点软钢阻尼器的减震效果。

• accordingly i, suggested to him, yield point of his scrape together.

  因此我，给他建议了一下，让他东拼西凑点。

• for smaller components, use of a material with a lower yield point is best.

  而对于小型元件，则采用低屈服点贴片胶最为适宜。

• it must be emphasized that the absence of a definite yield point does not in itself imply that the material has a low ductility.

  必须强调的是，没有明显的屈服点并不意味材料有较低的韧性。

• the yield point and max strain in circumferential direction are more than 70%.

  而垂直管腔纵轴拉伸组的屈服点应变和最大应变较大，达70％以上。