片语

Yield Strength Ratio屈强比

low yield ratio低屈强比

relative yield ratio或相对收益率

yield d ratio屈服比

isomeric yield ratio同质异能素产额比

liquor yield ratio出酒率

yield loss ratio产量损失率

yield-ratio method产额比方法

Emergy Yield Ratio能值产出率

英汉例句

• Mechanical properties and fracture mechanism of high strength steel sheet with low yield ratio under impact loading have been studied through instrumented impact and quasi-static tensile tests.

  通过室温下的仪器化沖击试验和静态拉伸试验，研究一种低屈服比高强度钢板在沖击载荷下的力学性能和断裂机理。

• With the strain aging temperature increasing, strength and hardness increases, plasticity and toughness decreases, yield ratio has the ascending trend, hardening index decreases.

  随着应变时效温度升高，强度和硬度增加，塑性和韧性下降，屈强比呈升高的趋势，形变强化指数降低。

• The calculation showed that it raised the yield ratio of benzene from 94.2% to 98.2%. Since the modification of...

  改进后的计算结果表明苯的收率从94.2%提高到98.2%，且整个改进过程不复杂。

• So the microwave radiation could promote acid hydrolysis of plant fiber and significantly shorten the time of saccharification and raise the yield ratio of reducing sugar in the ionic liquid medium.

  由此可知，离子液体介质中，微波辐射加热能够促进植物纤维素的酸水解，并显着缩短糖化时间，使得还原糖的收率提高。

• But the tensile strength will be reduced a little, and the yield ratio increased.

  但抗拉强度将随卷曲温度的降低而有少量损失，而屈强比提高。

• Quenching and tempering heat treatment are integrated in order to improve the mechanical properties of fasteners to meet the product requirements of tensile strength and yield ratio value.

  热处理调质是为了提高紧固件的综合力学性能，满足产品规定的抗拉强度值和屈强比。

• At lower annealing temperature obtain high strength and high yield ratio showed cyclic softening feature easily. That is detrimental to the using life of coiled tubing.

  较低退火温度获得高强度、高屈强比易表现出循环软化特征，不利于提高连续油管的疲劳寿命。

• Raising the testing strain rate, the strength and yield ratio increased the plasticity slightly decreased, but the strain rate hardening index kept constant.

  应变率增加，材料强度提高，屈强比增大，塑性略有降低，但流变阶段应变率强化系数基本不变。

• With the rapid development of steel framed buildings, the steel plates for buildings must possess higher performances of strength, toughness, yield ratio and weldability, etc.

  随钢结构建筑的迅猛发展，对建筑用钢板的强韧度、屈强比、焊接性等提出了更高的要求。

• By using RQMD Monte Carlo generator model, we performed an investigation on the yield ratio of various particles in relativistic heavy ion collisions in high energy physics.

  本文用RQMD模型对高能物理中的相对论重粒子碰撞中的各种粒子的产额比进行了研究。

• The specific surface area, pore size and yield ratio have been measured. Iodine and Methylene blue adsorption were used to study the adsorption capacity of ACHF.

  测量了比表面积和得率，孔径分布，用碘吸附值、亚甲基兰吸附值测定了中空活性炭纤维的吸附性能，用SEM观察了其表面结构。

• Strain-hardening are mainly determined by strength, elongation and strength yield ratio of virgin steel, among which the strength yield ratio is the most important influence factor.

  板材冷作硬化效应主要取决于母材的强度、伸长率和强屈比，其中强屈比对型钢的冷作硬化效应影响最大；

• In this paper, steel plate for buildings with high strength and low yield ratio was studied in laboratory.

  本文对高强度低屈强比建筑用钢进行了实验室生产研究。

• Detailed studies are made on the effect of the microwave power, time of microwave radiation, the amount and varieties of catalysts, and the matching of reactant on the yield ratio of reaction product.

  研究了微波功率、辐射时间、催化剂种类和用量、反应物配比对反应产物收率的影响。