yield stress
[力] 屈服应力
2025-01-07 12:49 浏览次数 2
[力] 屈服应力
yield shearing stress屈服剪应力
yield-stress fluid屈服应力流体
yield tensile stress降伏抗张应力
yield shear stress屈服剪应力
flow stress[流] 流动应力;怜应力;屈服应力;流度应力
yield-stress ratio屈服应力比
yield point stress屈服点应力
bingham yield-stress屈服应力
yield value stress屈服应力值
it is known from experimental results that the sensitivity of dynamic yield stress of the two materials within different impact velocity zones are differed.
从实验结果得知,两种材料在不同撞击速度范围内其动态屈服应力的敏感度不同。
a modified theory of metal volume fraction is put forward to precisely predict tensile properties including elastic modulus, yield stress and tensile strength.
提出了修正后的金属体积分数理论,準确预测了材料的弹性模量、屈服应力及拉伸强度。
the effect of the definition of yield stress on the initial and subsequent yield surfaces.
不同屈服应力定义对初始屈服曲面的后继屈服曲面的影响;
shear yield stress was defined as the intercept point on the y-axis.
剪切屈服应力被定义为y轴上的交会点。
introduced arc the applications of dynamic yield stress in low temperature transportation as well as in the course of restart after shutdown of the waxy crude oil transport system.
介绍了动屈服应力在含蜡原油低温输送和含蜡原油停输后再启动过程中的应用。
the corrected predictions by using the dynamic yield stress are in satisfactory agreement with our experimental results.
采用本文公式并计及动态屈服应力所得出的最大残余挠度值,与实验结果取得满意的一致。
the results show that the micro - yield stress in surface layer is related to looding method and the stress-strain curve has a double linear character.
结果表明:表面微观屈服应力与加载方式有关;表面变形的应力应变曲线具有双线性特征。
comparing with the uniaxial compression, the young's modulus and the yield stress of the biaxial compression increase obviously.
与单轴压缩相比较,双轴压缩的弹性模量和屈服应力有明显的提高。
rotated rheometer was used to determine the yield stress of lithium lubricating grease.
选用旋转流变仪测定了锂基润滑脂的屈服应力。
electric-rhological(er) fluid is a smart material. when it is applied electric field, its viscosity, modulus and yield stress rapidly change and return an original state as electric field canceled.
电流变液是一种随外加电场的作用,液体的粘度、模量和屈服应力等发生迅速变化,而当电场取消后迅速恢复常态的智能材料。
vessel burst pressure is the mean between maximum event (explosion) pressure and the yield stress of the vessel.
容器爆破压力是容器屈服应力和最大事件(爆炸)压力之间的平均数。
yield stress is the stress at which a material begins to deform plastically.
屈服应力是材料开始发生弹性型变时的压力大小。
a comprehensive description is given to the abnormal yield stress of nickel base single crystal superalloy. meanwhile, the deformation mechanism of nickel base single crystal superalloy is discussed.
综述了镍基单晶高温合金的反常屈服行为,并讨论了导致产生这种反常屈服行为的变形机制及这些变形机制的发展过程。
especially, this model can also explain the yield stress and wall slip phenomena for foam fracturing fluid.
更为主要的是该模型还可以用于解释泡沫压裂液的屈服应力和壁面滑移现象。
this paper introduced a new method of testing the static yield stress of electrorheological (er) fluids.
本文介绍了一种新的电流变液静态屈服应力测试方法。
for a rigid-plastic material, only the yield stress is required.
而要建立一个刚塑性模型,只需要屈服应力就够了。
results show that with the increase of cooling rate or decrease of measurement temperature, both the yield stress and yield time increase, but the yield strain decreases.
发现在相同测量方式下,随降温速率的增大或测量温度的降低,屈服应力增大、屈服时间变长、屈服应变减小。
by the use of this method, the relationship between static yield stress and temperature can be obtained by continuous measurement.
利用该方法能连续测出物料静屈服值与温度的关系,能测量一定历史条件下含蜡原油的始凝点。
the results show that the influences of the glass beads content and its diameter on the tensile yield stress and strain at yield are not significant.
结果显示,微珠含量及其直径对复合物的拉伸屈服应力和屈服发生时的应变影响不太明显。
the present work shows that there is a linear correlation between the cleavage fracture stress and the yield stress in the above mentioned materials at low temperature of -196c.
还发现在零下196℃下解理断裂应力与屈服应力之间存在良好的线性关系。
as for intervertebral space, the cranial endplates had a higher yield stress than caudal endplates(p0.05).
椎间隙相邻面上一椎体下终板的抗压强度大于下一椎体上终板(p<0.05)。
the critical reynolds number is, given in the case of long waves, and the effect of yield stress on stability is analysed.
在长波解情况下,得到了临界雷诺数的近似表示,并分析了屈服应力对流动稳定性的影响。
the yield stress of our mr fluid is of good thermal stability.
磁流变液的屈服应力对温度具有很好的稳定性。