片语

Zinc Phosphating Coating锌系磷化膜

zinc silicate coating锌硅酸盐涂层

galvanize镀锌；通电；刺激

inorganic zinc silicate coating无机硅富锌涂料

zinc phosphate coating锌系复合磷化膜

Zinc-coating plate镀锌板

Zinc rich coating富锌涂料

zinc plating镀锌

zinc powder coating锌粉涂层

zinc-coating layer镀锌层

英汉例句

• hot dip galvanization is the present widespread application used in anticorrosion for zinc coating w-beams barriers.

  热浸镀锌工艺目前广泛应用于高速公路波形梁钢护栏防腐处理。

• the effects of pulse current, frequency, duty ratio and inverse current in zincate system on the appearance and corrosion resistance of zinc coating are investigated.

  研究了在锌酸盐镀锌体系中采用脉沖电流时，脉沖频率、脉沖的占空比、反向电流对镀层外观、耐蚀性的影响。

• at the same time, the binder in the cold spraying zinc coating also provides an additional barrier protection, so as to slow down the oxidation of zinc.

  同时冷喷锌涂料中的粘合剂也提供一层附加的屏障保护，从而减缓锌的氧化。

• comparing tests under water showed that the specimens with hierarchical coating were more resistant to corrosion and other damages than the specimens with only zinc coating or stainless steel coating.

  与单独喷锌或喷不锈钢试样进行了水下对比试验，结果表明，喷涂阶梯涂层试样水下耐蚀和抗破坏效果显着。

• apply to properly blast cleaned steel or directly over inorganic zinc coating in good condition.

  适用于正确处理的金属表面，或直接施工于状态良好的无机富锌涂层之上。

• the presence of zinc coating on steel does not restrict steel's recyclability and all types of zinc-coated products are recyclable(4).

  钢铁上镀锌的存在并不会限制钢铁的回收，所有镀锌产品都是可以回收的。

• the zinc coating at the outside of the bent or formed section is visible at 25 power magnification.

  或成型区在25倍放大时可看见镀锌层片状材料脱落或裂化，认为锌镀层已损坏。

• the application situations of common used passivation technology for zinc coating including technological conditions, film properties and characteristics were introduced systemically.

  系统地介绍了常用镀锌钝化工艺的应用状况，包括工艺条件、膜层性能、特点等。

• a zinc coating is applied to the steel for rust protection.

  镀锌层是用来防止钢铁生锈的。

• finer, more uniform and denser zinc crystals were attained by secondary zinc coating with better covering capacity.

  二次浸锌得到的锌晶粒比一次浸锌更细小、均匀和致密，对基体覆盖能力好。

• for the purpose of improving quality of galvanized products and reducing cost of production, the zinc coating online measuring technology has been brought to a rapid development period.

  为了提高镀锌产品质量及降低生产成本，锌层测量技术在近年来得到了快速的发展。

• zinc coating the use temperature should not be more than 250 ℃, the temperature above zinc crystallization organization deformation, sent fragile, corrosion resistance down.

  锌镀层的使用温度不得超过250℃，在此温度以上锌结晶组织变形、发脆、耐蚀性下降。

• galvanized steel is widely used in industry due to its excellent corrosion resistance. however, the zinc coating greatly reduces the welding process property of galvanized steel.

  镀锌钢因其良好的抗腐蚀性能而广泛应用于各个领域，而镀锌层的存在使得镀锌钢的焊接过程和焊接质量受到不利影响。

• influences of chromating temperature, immersion time and dry temperature on performances of the chromated zinc coating are also discussed.

  讨论了钝化温度时间及干燥温度等对钝化膜层性能的影响。

• zinc coating was prepared using mechanical plating technology for the deposition of small amount tin salt.

  采用少锡盐沉积机械镀锌工艺制备了机械镀锌的镀层。

• apply on properly blast cleaned steel or directly over inorganic zinc coating in good condition.

  施工于适当处理的钢材 表面上，或直接施工于状态良好的无机富锌涂层之上。

• with the increase of temperature, the weight loss of zinc coating increases.

  且随着温度的升高， 镀锌板的锌层脱落量增加。

• the continuous zinc coating envelops the entire volume, integrating the drain and the ventilated cavity without interruption.

  持续的锌质表皮包围整个体量，巧妙地融合排水和通风口。

• the structure change of zinc coating after deformation has also been investigated. the second adhesion mechanism duri…

  还研究了镀层受力变形后的结构变化，并提出二次粘附成型机理。

• surface quality adhesion to substrate and corrosion resistance of zinc coating of mechanical plating are described. the deposition model is proposed and is confirmed by experimental results.

  阐述了机械镀锌层的表面质量、结合力及其耐蚀性，提出了机械镀锌的沉积过程模型。通过实验数据及分析加以验证。